GYS GYSPACK AUTO - Page 12

12
GYSPACK AUTO / 400 / 600
EN
Translation of the original instructions
Disposal:
• This product should be disposed of at an ap-
propriate recycling facility. Do not dispose of in
domestic waste.
• The battery fitted in this device is recyclable.
Please proceed according to the applicable re-
cycling regulations.
• The battery must be removed from the device
before the latter is discarded.
• The device must absolutely be disconnected
from the power supply network before remo-
ving the battery.
GENERAL DESCRIPTION
This autonomous starter is intended for the starting of vehicles equipped with a 12 V battery. GYSPACK functions thanks
to a high performance battery. For an appropriate use of the machine and a longer lifetime of its internal battery, it is
essential to connect to the sector the GYSPACK after each use and keep it connected until the next use.
Warning: To avoid any damage or explosion, respect the polarity during the clamp connection.
PRODUCT INTERFACE
1
2
3 4
5
1
Connection for the charger-adapter. Use only the charger-adapter provided with the product.
2
Red light
- Test mode: obligation to reload - Warning: never use the Gyspackauto when the red indicator lights on.
- Charger mode: the battery is charging.
3
Yellow light (test mode only): It is strongly advised to reload before use
4
Green light
- Test mode: The battery is charged. Can be used for starting vehicles.
- Charger mode: charge is nished. Floating: you can keep the product connected to the main supply.
5
Test Button: press this button to check the battery level.
TESTING OF THE INTERNAL BATTERY
Test the battery before each use: press on the test button, the result is displayed as follow:
- Green indicator: The battery is charged. Can be used for starting vehicles
- Orange indicator: It is strongly advised to recharge the GYSPACK before use.
- Red indicator: obligation to recharge.
Warning: never use the Machine when the red indicator is on.
STARTING OF A VEHICLE
Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information
and a possible inability to restart.