GYS Tool it DBT 300 User Manual

Translation of the original instructions
SAFETY INSTRUCTIONS
This manual includes guidelines on the operation of your
device and the precautions to follow for your own safety.
Ensure it is read carefully before rst use and keep it
handy for future reference.
Risk of explosion and re!
A battery being charged can emit explosive gas.
The battery tester should only be connected to batteries
with a rated output voltage of 12 V.
CAUTION: Reverse polarity will cause the fuse to blow
and could cause permanent damage. Damage due to
reverse polarity is not covered by our warranty.
CAUTION: If the car’s battery is disconnected, some
management systems may be disabled.
Consult your vehicle manual for more information on
installation.
Do not use the battery tester if the cord or terminals are
damaged.
Do not use the battery tester if it has received a severe
shock or has been damaged in any way.
Do not disassemble the device. Incorrect reassembly may
result in a risk of electric shock or re.
Acid projection hazard!
• Wear appropriate safety glasses and clothing.
• If your eyes or skin come into contact with battery acid,
rinse the affected part of the body with plenty of water
and seek immediate medical assistance.
• Avoid ames and sparks. Do not smoke.
• Protect the electrical contacts of the battery against
short-circuiting.
• The device complies with European Directive.
• The certicate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
• Material conforms to UK requirements. The UK
Declaration of Conformity is available on our website
(see cover page).
• Device compliant with Moroccan standards.
• The Cم (CMIM) declaration of conformity is available
on our website.
• This product should be disposed of at an appropriate
recycling facility. Do not dispose of in domestic waste.
• Recyclable product that falls within waste sorting rec-
ommendations
CONNECTING THE BATTERY TESTER
1- Make sure that the area is well ventilated before performing a test.
2- Tester for 12 V batteries (and START & STOP 12 V batteries) and test of the
charging system.
3- Before performing a test on the battery, make sure that the ignition and the
consumers are switched o.
Close all doors and the boot.
4- Make sure that the battery connections are clean. If necessary, clean them
with a wire brush.
The presence of oxydation between the tester terminals and the battery
connectors or between the connectors of the battery and the terminals de-
creases the tester eciency.
5- Connect the negative (black) terminal to the negative terminal of the battery.
Connect the positive terminal (red) to the terminal positive of the battery.
6
DBT 300
EN

GYS Tool it DBT 300 Specifications

General

Brand	GYS
Model	Tool it DBT 300
Category	Test Equipment
Language	English