continue happen for more than 60 seconds, please check whether water tank and filter
assembled correctly or not
a.
When set selection button at "NYLON" position, no steam escaped since it only just suits for
dry ironing.
b.
When set fabric setting at "POLYESTER"
/
"RAYON"
/
"COTION"
"LINEN" ,steam willautomatically vary according to sole-plate temperature. Pump will stop
working and no steam escaped when sole-plate temperature decrease too
low.lt
will
resume after reheated to desiredtemperature.
Dry ironing
1.
Connect the appliance to a suitable socket outlet, lay handle down. Power indicator light
(red} "<!) "on iron unit light up
,it
indicates that the unit has been connected to power
supply.
2.
Set selection button to desired position according to above fabric setting chart. Blue
indicator light at iron unit blinks slowly to indicate the unit being heated up. When the blue
indicator
light
change to light up steadily and an audible "Bi" signal produced, the desired
temperature has been reached. During use, blue indicator light will cycle from blinking to
light
on steadily, and then from steady mode to On.
lt
does not indicate a defects or hazard,
it is
just because the appliance are temperature constant.
3.
After use, put iron unit back onto the base unit again, turn selection button to"
<!)
",and then unplug the appliance from main socket .
Note:
When changing your Temp setting from higher setting to lower, it is proposed that
not to start ironing immediately since
it
may cause burns to your fabrics. Please wait
till
blue
indicator
light lights
up steadily, and then
start ironing.
Vertical steam ironing
Follow the steam ironing process, and then hold the iron
in
vertical position between 5cm and
15cm away from the hanged fabrics. Press down steam switch, this will create vertical steam.
This feature is especially used for removing creases from hanging clothes and curtains. Never
directly perform steam ironing on people.
Auto shut off function
The appliance willcorne intoauto shut off modealong with audible "Bi..." signal when ithas been used for
60 minutes continuously with temperatureset atany settings,
power
indicator
light"
c!)"Blink.
Press
selection
button
to
reset
another
60
minutes
cycle if continuous use is necessary.(Note:once each setting
is pressed,the unit will
reset time)
To Next Page
Loading...
