12
6 Configuring basic functions
Default configuration
The WX series access controller has the default configuration as follows (see Table 2 ):
NOTE:
The default output depends on your AC model.
#
version 5.20, Release 2106P01
#
sysname H3C
#
undo info-center logfile enable
#
domain default enable system
#
telnet server enable
#
port-security enable
#
vlan 1
#
domain system
access-limit disable
state active
idle-cut disable
self-service-url disable
#
user-group system
#
local-user admin
password simple admin
authorization-attribute level 3
service-type telnet
#
wlan rrm
dot11a mandatory-rate 6 12 24
dot11a supported-rate 9 18 36 48 54
dot11b mandatory-rate 1 2
To Next Page
Loading...
