© 2012 Haas Automation, Inc. 96-0056 rev P 3/12 2
the operator must stay within the Operator Zone (as shown in
operation of this machine all personnel must remain outside of
the Stay Clear Zone.
Areas of the machine, especially
on open frame mills, may have
the machine should be such that it
will limit the access to the machine.
This machine moves quickly. It is the shop owners responsibility to provide mea-
Photoelectric beams are used to stop the machine should personnel or equipment enter the protected area.
1. INSTALLATION
Air Requirements
Electrical Requirements
Power Supply 50 AMP 25 AMP
Haas Circuit Breaker 40 AMP 20 AMP
If service run from elec. panel
If service run from elec. panel
NOTE:
To Next Page
Loading...
