To Next PageTo Next Page
Need help?Do you have a question about the HACH LANGE EVITA OXY Series and is the answer not in the manual?
General| Measurement Principle | Optical (Luminescence) |
|---|---|
| Operating Temperature | 0 - 50 °C |
| Pressure Range | 0 - 10 bar |
| IP Rating | IP68 |
| Resolution | 0.01 mg/L O2 |
| Response time (t90) | <60 seconds |
| Cable length | 10 m (standard) |
| Material | Stainless steel, POM |
| Communication | RS485, Modbus |
| Power Supply | 24 V DC |
| Measurement Range | 0 - 20 mg/L O2 |
Details transmitter specs, sensor ranges, and measurement limits for the EVITA OXY.
Covers system accuracy, reaction times for OXY 1100, and membrane integrity monitoring.
Specifies environmental conditions, power supply requirements, materials, and approvals for the device.
Provides safety notes, danger symbols, and interpretations of device warning labels.
Presents an overview of the EVITA OXY system components, including sensors and transmitters.
Details mechanical installation notices, assembly of parts, and mounting options.
Instructions for installing USC units on handrails or concrete walls.
Steps for unpacking, inserting, and connecting an optional module to the USC 7000.
Covers essential electrical safety, disconnecting devices, earthing, and outdoor connection guidelines.
Details requirements for power supply connection, including fuses, and instructions for cable stripping.
Illustrates connections of EVITA OXY to PLC/SCADA systems with and without external power supply.
Details USC 7000's HART multidrop capability and connecting multiple transmitters.
Describes keypad functions, display symbols, and USC programming operations.
Outlines menu structures, default settings, and navigation through operator and setup menus.
Configuration settings for USC current and relay outputs, including function and value settings.
Explains how to configure the operator menu to hide or show specific submenus.
Details calibration frequency, methods, and sensor cleaning procedures.
Accessing transmitter and USC signal converter information like versions and logs.
Procedures for resetting the system to default values and executing commands.
Options for advanced calibration types, compensation factors, and transmitter addressing.
Guides on diagnosing errors, displaying messages, and accessing event logs for transmitter and USC.
Detailed troubleshooting steps for specific transmitter symptoms like signal errors and incorrect values.
Detailed troubleshooting steps for USC issues like display errors, output value problems, and communication faults.
Details values readable via HART and tasks performable during calibration/replacement.
Explains how to program settings like measurement range and tilt switch via HART.
Lists default values, oxygen solubility data, and zero point check instructions.
Outlines warranty terms and provides contact information for support and service.
Contact details for HACH Company World Headquarters and repair service in the United States.
Contact information for HACH LANGE offices in Canada, UK, France, Ireland, Belgium, Austria, Netherlands.
Contact details for HACH LANGE offices in Denmark, Portugal, Hungary, Slovenia, Poland, Romania, Greece, etc.
