A1000 - Manual Overview 7 of 176
RPS - July 2007 - Edition 9
Anatel Operator Manual
Manual Overview
About This Manual
The information in this manual has been carefully checked and is believed to be accurate.
However, Hach Ultra assumes no responsibility for any inaccuracies that may be contained in
this manual. In no event will Hach Ultra be liable for direct, indirect, special, incidental, or
consequential damages resulting from any defect or omission in this manual, even if advised of
the possibility of such damages. In the interest of continued product development, Hach Ultra
reserves the right to make improvements in this manual and the products it describes at any
time, without notice or obligation.
Published in the United States of America
Hach Ultra P/N: FG5700301 Edition 9, July 2007
Copyright © 1994-2007 by Hach Ultra Analytics, Inc.
All rights reserved. No part of the contents of this manual may be reproduced or transmitted in
any form or by any means without the written permission of Hach Ultra.
Safety Conventions
A warning is used to indicate a condition which, if not met, could cause serious personal injury
and/or death. Do not move beyond a warning until all conditions have been met.
A caution is used to indicate a condition which, if not met, could cause damage to the
equipment. Do not move beyond a caution until all conditions have been met.
A note is used to indicate important information or instructions that should be considered
before operating the equipment.
General Safety Considerations
• All service procedures should be conducted by properly trained service personnel.
• Make sure the A1000 TOC Analyzer is properly installed and all hydraulic connections
are correctly installed before operation. All safety guidelines should be observed.
• Follow all procedures in “Return Procedures” on page 155 before shipping a unit to a
service center for repair or re-calibration.
Use of controls or adjustments, or performance of procedures other than those specified
herein may result in hazardous radiation exposure.