A1000 - Manual Overview 9 of 176
RPS - July 2007 - Edition 9
Anatel Operator Manual
This instrument has been tested and found to comply with EMC Directive 89/336/EEC and is in
conformity with the relevant sections of the following EC standards and other normative
documents:
† The product was tested in a typical configuration of the Anatel TOC Monitoring System.
The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC
and the EMC Directive 89/336/EEC. The subject products were also tested by LGA Ref
#EMC-295/2129 for certificate of conformity to EMC directive, and LGA GS Mark Certificate
#9741007, conformity to LVD directive.
The CE Marking has been affixed on the devices according to the EU Directive 89/336/EEC.
The Anatel A1000 TOC Analyzer supports those parts of 21 CFR, Part 11 concerning the
collection, retention, access and retrieval of data as electronic records. The instrument uses no
electronic signature(s), thus those parts of the rule referring to electronic signature(s) are not
applicable. Extensively documented and verifiable tests have been conducted to establish
21 CFR, Part 11 compliance.
The Anatel A1000 TOC Analysis System is comprised of a line of precision instruments which
meet or exceed the following international requirements and standards of compliance:
The A1000 TOC Analyzer System is comprised of a line of precision instruments which meet
or exceed the following international requirements and standards of compliance:
Safety: LVD EN 61 010–1:1993 + A2:1995
EMC: CENELEC EN 50 081–2:1993, Class B†
• Conducted EN 55 011:1992, Class B, Group 1
• Radisted EN 55 011:1992, Class B, Group 1
CENELEC EN 50 082–2:1995
• IEC 801–2, EN 61 000–4–2; 4kV CD, 8kV AD
• IEC 801–4, EN 61 000–4–4; 2kV Signal Lines, 2kV Power Lines
• IEC 801–3, ENV 50 140, EN 61 000–4–3; 10V/m
• IEC 801–6, ENV 50 141, EN 61 000–4–5; 10V
EN61010–1
Electrical Equipment for Laboratory Use,
Part 1: General Requirements
CAN/CSA–C22.2 No. 1010.1–92
Safety Requirements for Electrical Equipment for Measurement, Control and
Laboratory Use, Part 1: General Requirements
Customer satisfaction through continuous quality improvements.
In addition, the following international symbols are found on the instruments
Standby
Reference Document: IEC 417–5009
Protective Earth Ground
Reference Document: IEC 417–5019
To Next Page
Loading...
Need help?
General
