Hacker X Series - Program Mode

To Next Page

To Previous Page

Drehzahlstellerprogrammierung

/ ESC program procedure

Programmiermodus

Gasknüppel auf Vollgas, Akku anstecken, Schalter (falls vorhanden) einschalten. Nach 5 sec. sind Sie im

Programmiermodus und hören eine Tonfolge: __--

Program mode :

X-7, X-12, X-20, X-30- With throttle stick at full power, connect the battery and wait for 5

sec. Program mode is entered when you hear two low tones and two high tones. _ _ - -

Each time you enter the programming mode you are allowed to make one change and

then you will automatically exit the programming mode. To change more than one

parameter you will have to re-connect the battery

and re-enter the programming mode

each time.

X-40- With throttle stick at full power, the ESC switch must be in the on position,

connect the battery and wait for 5 sec. Program mode is entered when you hear two low

tones and two high tones. _ _ - - Each time you enter the programming mode you are

allowed to make one change and then you will automatically exit the programming mode.

To change more than one parameter you will have to re-connect the battery

and

re-enter the programming mode each time.

1. Bremse / Brake

Wenn Sie innerhalb 5 sec nach der ersten Tonfolge den Gasknüppel in die Motor-Aus-Position bringen wird der

„Bremsmodus“ gewechselt (ON -> OFF, oder OFF ->

ON)

To change the brake function, as soon as you hear the programming tones mentioned

above, move the throttle stick to low position. Brake function will be inverted. (IE: If brake

was on, it now will be off.)

To change any of the remaining functions, enter the programming mode as detailed

above. Leave the throttle at high position until you are within the five sets of beeps as

detailed in each of the choices below. When you arrive at the choice you want to make,

move the throttle to low position while that series of 5 tones are still being heard.

2. Akku Typ / Battery type

(Abschaltspannung) / (Voltage Cut-off)

NiCad:

. . . . .

2 Lipos: (5.8V)

.. .. .. .. .. ..

3 Lipos: (7.8V)

... ... ... ... ...

3.Abschaltsystem bei Unterspannung / Under voltage