How to improve the sealing quality of my Hacona Food Saver?
If the sealing quality of your Hacona Food Saver is not acceptable, try adjusting the sealing time using the regulatory button. Remember that the sealing time should increase proportionally with the width of the film you are using. Also, ensure you wait for the adequate cooling time (1-2 seconds) after sealing, as this time should increase proportionally with the sealing time.
What to do if my Hacona C Series does not weld and the LED doesn't light up?
If your Hacona Food Saver isn't welding and the LED isn't lighting up, first check that the machine is properly connected to a working 230V electricity supply. If the power supply is fine, the control panel might be damaged.
Why my Hacona C Series doesn't weld, the LED is yellow, but doesn't turn red?
If your Hacona Food Saver isn't welding, the LED shows yellow but doesn't turn red when closing the handle, make sure you are pressing the handle down firmly – avoid pressing it sideways. Also, check that the front cap is properly attached to the handle and that the magnet is inside it. If the problem persists, the control panel may be damaged.
What to do if my Hacona C Series Food Saver doesn't weld, even though the LED lights are working?
If your Hacona Food Saver isn't welding, even though the LED lights are functioning correctly, unplug the machine from the electricity supply immediately. Then, inspect the sealing wire, Teflon tapes, and the transformer to ensure they are all intact.
Why does the sealing wire of my Hacona Food Saver heat up as soon as I plug it in?
If the sealing wire of your Hacona Food Saver starts heating up immediately upon connecting to the electricity supply, the control panel may be damaged. Unplug the appliance from the power supply without delay.
General| Brand | Hacona |
|---|---|
| Model | C Series |
| Category | Food Saver |
| Language | English |
Details the types of film, thickness, sealing length, and width the machine can handle.
Explains how to identify the machine using type and serial number, and the meaning of markings.
Provides instructions on handling and placing the machine after unpacking.
Specifies ideal operating temperature and humidity for the machine.
Illustrates and lists the components of the sealing machine, detailing each part.
Describes the basic steps for operating the sealing machine, including setting time and sealing.
Lists essential checks before using the machine, including inspecting for damage.
Details how to safely connect the machine to the electricity supply, emphasizing voltage matching.
Explains how to set the sealing time using the regulatory button for optimal sealing results.
Instructs on how to use the built-in knife for cutting film and preparing bags from rolls.
Presents a table with specifications like sealing length, film width, and dimensions for different models.
Lists materials that should not be sealed due to safety hazards.
Highlights critical safety warnings, such as avoiding contact with the hot sealing wire.
Provides guidance on cleaning the machine, including warnings about solvents and the knife.
Detailed steps for replacing teflon tapes and the sealing wire, including component identification.
Instructions for removing and installing the silicone rubber profile on the sealing bar.
Guidance on replacing the knife and the entire knife assembly.
Diagrams and part lists for the electrical connections and components of the machine.
Explains the location of the fuse and the procedure for replacing it, emphasizing safety.
States that repairs and internal setup should only be done by trained specialists.
Lists and illustrates common wearing parts of the machine, such as rubber, tapes, and blades.
Provides guidelines for the proper disposal of machine parts, emphasizing environmental regulations.
States the guarantee period and the requirement for the original receipt.
Outlines the terms and conditions under which the guarantee is valid or invalid.
To Next Page
