hager EE600 - Page 11

Luminosity
Sensitivity
(modication
of the range)
Fixed time
(length of time
of lighting)
Adjustments
Detection zones
Testing and validating
the detection zone
Put the potentiometer 2 on Test mode and
if necessary, use the shutters to dene the
detection zone.
The Test mode is available for 3 min. Every
movement detected switches on the light for 1s.
After 3 min without detection of movement, the
product returns to normal operation.
“Normal” operation (on/off)
The light panel switches on when the luminosity
level dened by potentiometer 2 is judged to be
insufcient and when a movement is detected.
After detection, the light stays on for the length
of time predened by the potentiometer 1. The
xed timing is reset after each detection.
Please note : when the potentiometer 2 is on
“auto test”, the settings are predened (See table
below).
ech30%
α
α


Optimal installation height is 2.5m.
The detection zone shall remain free of obstacle.
ech40%
vue 30-30°
cfg
fct
vue 30-30°
vue 30-30°
cfg
fct
a
b c
8 m 12 m
Ø 6 m
2,5 m
8
z