hager LCP01U - In the Handset

1. Take the handset off its base and remove
the belt clip by pressing on one of its
sides.
2. Insert a flat screwdriver into the slot and
press to open the handset.
When you change the controller batteries, it is also advisable to change the handset batteries.
3. Replace the flat MTU01X battery with a
new once.
4. Close the handset, put the belt clip back
on and then place the handset back on
its base in order to start it up.
5. Programme the time
using and .
The temperature display will be updated
several minutes after the handset has
been powered.
If necessary, the
icon flashes to indicate that
the handset is charging.
3.5
C
IMPORTANT:
• There is a risk of explosion if the battery/ies
is/are not properly replaced.
• Replace the flat battery/ies with the same type.
• Do not expose the battery to excessive heat
(e.g. a flame) and do not throw it in a fire.
Dispose of flat batteries in the appropriate
waste disposal containers.
Li
230
GB
10.2 In the handset