Need help?Do you have a question about the HAI Omni and is the answer not in the manual?
General| Voice Dialer | Yes |
|---|---|
| Control Type | Touchscreen, Keypad |
| Communication | Ethernet |
| Automation Protocols | UPB, Z-Wave |
| System Type | Wired/Wireless Hybrid |
| Power Supply | 12V DC |
| Operating Temperature | 0° to 50° C (32° to 122° F) |
| Humidity Range | 0% to 95% RH, non-condensing |
Details the importance of planning the system installation and using the planner/checklist.
Provides general steps for system installation.
Detailed instructions for connecting the main controller unit.
Describes how to properly wire burglar zones.
Describes how to properly wire fire zones.
Instructions for connecting the system to phone lines.
Physical connection guide for LCD consoles.
Configuration for console address, sounder, and display settings.
Controls for key click, backlight, and viewing adjustment.
Console language selection and functional testing procedure.
Connecting the interior sounder to the system.
Connecting the exterior sounder to the system.
Using outputs for various switching tasks.
Using outputs to trigger sounders and communication devices.
Configuring outputs for system status indicators.
Connecting and configuring a remote keyswitch.
Integrating X-10 or compatible modules.
Connecting and configuring PESMs and their HVAC interaction.
Installing and configuring Model 14A00 temperature sensors.
Steps to power up and verify the system's operation.
Verifying console operation after system power-up.
Verifying phone line connectivity and burglar zone functionality.
Verifying fire zone operation and home control modules.
Ensuring customer understanding of system operation.
General troubleshooting for consoles and controllers.
Tips for resolving issues with X-10 devices.
Explains the 4/2 communication format.
Configuring X-10 house code and phase settings.
Assigning types to controller outputs.
Configuring zone expansion and response settings.
Setting types for zones 1-32.
Descriptions of various zone types (Entry/Exit, Perimeter, etc.).
Details on Panic, Tamper, Police Emergency, Duress, Fire, Gas zones.
Defining system areas and linking units.
Linking zones and macro buttons to specific areas.
Linking consoles to specific or global areas.
Assigning thermostats to specific system areas.
Setting display format and thermostat types.
Setting installer and PC access codes.
Configuring a number for remote access callbacks.
Setting delays for outside sirens and dial outs.
Configuring alarm reset time and arming feedback.
Feature to reduce false fire alarms.
Activating or deactivating emergency keypad functions.
Setting time and date display preferences.
Configuring AC frequency and phone line detection.
Compensating for clock speed variations.
Resetting EEPROM and RAM.
Defining types for expansion modules.
Setting the communication speed for serial ports.
Provides technical specifications for the Omni system.
Specific requirements for UL compliance.
Diagram illustrating battery backup connections.
Best practices for smoke detector placement.
Template for planning and verifying installation.
To Next Page
