Indoor Unit
87
Super Match
PREPARING INDOOR UNIT INSTALLATION
Remove the intake grill
Open the intake grill and remove the three or four or six screws.
Note:
The main unit can be wired before the indoor unit is installed. Select the
most appropriate installation order.
A.FLOOR CONSOLE TYPE
1. Drilling for piping
Select piping and drain directions. The piping and drain can be made
in three directions as shown in the Fig.1.
The drain hose can be connected to either the left or right side. (Fig.2)
When the directions are selected, drill a 7 cm dia. hole on the wall
so that the hole is tilted downward toward the outdoor for smooth
water ow. When the pipe is led out from the rear, make a hole at the
position shown in Fig.3.
When installing set to wall, install the accessory wall
bracket at the position shown in Fig. 4, and mount the
set to it.
2. Installing drain hose
Select whether the drain hose will be connected to
the left or right side (Fig.2). Insert the drain hose into
the drain pan, then secure the drain hose with a nylon
fastener (Fig.5).
Wrap the insulation (drain hose) around the drain
hose connection. (Fig.6)
To Next Page
Loading...
