Cut intake grill for drain pipe
(1) Tools:Knife or Pliers.
(2) Cut the intake grill before installing the drain pipe,Then,pass the drain pipe through the hole.As the following schematic.
Installing the drain pipe and the connecting pipe
(1) When the unit is installed in the ceiling,Installing them as below.
d
rain pipe
(2) When the unit is installed on the floor,Installing them as below.
ceiling
connecting
pipe
d
rain pipe
connecting
pipe
Floor
16
CAUTION
When the unit is installed in the ceiling,side B is lower than side A for condensate discharge.As below.
10mm-15mm
10mm-15mm
A
B
A
B
Location of the cut
After removal
To Next Page
Loading...
