5
_
8mm
3
2
2
1
4
Holding ring
Piping hole position
Swing flap motor
Fig. 7
Seal
Indoor unit
Ceiling material
Ornament panel
(2)
Remove cover plate at corner
Tear off the adhesive tape,
and slide it off.
(Refer to Fig. 3)
(1)
(2)
2. Install ornament panel on indoor unit.
As shown in Fig . 7, match the position of
swing flap motor with that of the indoor unit
piping hole , so that ormament panel can be
placed on to indoor unit.
Installation of ornament panel
Place the holding ring on swing flao motor
side teporarily on hooks of the indoor unit.
(2 pcs)
Put the other two holding rings on the hooks at
both side of the indoor unit. (Care should be
taken not to push wiring of swing flap motor
into seals).
Screw in all 4 screws under holding ring for
about 15mm. (Pancl will rise).
Adjust the ornament panel as per Fig. 7 to
cover opening on the ceiling.
Tighten screws to redrce the thickness of seals
between ornament and indoor unit to 5-
8mm.
1
2
3
4
5
If indoor unit is at horizontal level
and water drainage is smooth,
then, indoor unit height can be ad-
justed throrgh holes at corners of
ornament panel.
If screws are not tighten tight, problems in Fig, 8
might occur. Tighten screws properly.
If there are still space after tightening
of screws, please readjust the height
of indoor unit. (Refer to Fig. 9)
Leave no space.
Fig. 9
Gas leakage.
Gas leakage from roof.
Contamination
Mist exists and drop down.
Fig. 8
45
Fig. 2
Adhesive tape
Slide
Fig. 3
For indoor unit installation, please refer to Installation Manual.
Hook
Caution
1
2
Leave no space.
Fig. 6
3. Mounting on high ceiling
(1) Ornament panel can be mounted on ceiling as high as 3 m.
(2) Please install pad as accessary.
Cut open the pad along cutting ling. Use part a only and discard part b . (Refer to Fig. 4)
Install part a of the pad on the place shown in Fig. 5. Refer to Fig. 6.
Fig. 4
(3)Wiring on ornament panel
Connecting of wiring of the swing
flap motor on ornament panel. (2 places)
(Refer to Fit . 10)
50
Cutting line
100
a
b
Place it on the frame.
Part a of the pad
Part a of the pad
Swing flap motor
Fig. 5
Side of ornament panel
Fig. 10
Wiring diagram
Side of indoor unit
If connecting is not made, error code
(A7) appears on remote controller. So,
make proper connecting.
INSTALLATION INSTRUCTIONS
To Next Page
Loading...
