To Next PageTo Next PageWhy is my Haier Air Conditioner not cooling well?
Poor cooling can occur due to several reasons. Check if the air filter is dirty and clean it every 15 days. Ensure there are no obstacles blocking the inlet and outlet. Verify that the temperature is set correctly. Make sure all doors and windows are closed. If there's direct sunlight, use curtains. Also, consider if there are too many heat sources or people in the room.
What to do if my Haier AS09GB2HRA Air Conditioner doesn't restart immediately?
When the unit is stopped, it won't restart immediately until 3 minutes have elapsed. When the electric plug is pulled out and reinserted, the protection circuit will work for 3 minutes to protect the air conditioner.
Why does my Haier Air Conditioner blow mist?
During COOL or DRY operation, the indoor unit may blow out mist due to the sudden cooling of indoor air.
Why does my Haier Air Conditioner make noise?
During operation or when the unit stops, a swishing or gurgling noise might be heard, especially in the first few minutes after starting due to refrigerant flowing. A cracking noise can also occur because of the casing expanding or shrinking with temperature changes. If there's a big noise from airflow during operation, the air filter may be too dirty.
Why does my Haier Air Conditioner smell?
The air conditioner might be circulating smells from the room, such as odors from furniture, paint, or cigarettes.
Why can't I change the fan speed in dry mode on my Haier AS09GB2HRA Air Conditioner?
In DRY mode, when the room temperature becomes lower than the set temperature +2°C, the unit will run intermittently at LOW speed regardless of the FAN setting.
General| Energy Efficiency Ratio (EER) | 3.21 |
|---|---|
| Refrigerant | R410A |
| Power Supply | 220-240V, 50Hz |
| Weight (Indoor Unit) | 9 kg |
| Cooling Capacity | 2.6 kW |
| Type | Split Air Conditioner |
How to start the unit and choose operation modes (COOL, HEAT, DRY).
Lists necessary tools and specifies power source requirements.
Criteria for selecting the best place to install the indoor unit.
Steps for preparing the wall and mounting the plate.
Procedures for linking indoor and outdoor unit electrical connections.
Detailed guide for connecting cables between units.
