Haier AS25PBPHRA-PRE - 3-Level-Eco Operation

8
EN
3-Level-Eco Operation
Operation
The 3-Level-Eco function is an active energy-saving function,
which can be activated by pressing the ECO button on the remote
controller ( ). The cycle goes as: L1→L2→L3→exit.
Press the ECO button once to enter L1 mode,
Press the ECO button again in L1 mode to enter L2 mode,
Press the ECO button again in L2 mode to enter L3 mode,
Continue to press the ECO button in L3 mode to exit this function.
After each press of the ECO button, the remote controller screen
and air conditioning panel display L1/L2/L3 respectively for ve
seconds, and then return to the previous display.
The maximum energy-saving rate is 52%.
Remark:
1.The indoor unit fan speed will be adjusted according to energy
saving logic after entering the ECO function.
2.Capacity may decrease when ECO function is selected. If this
does not meet your requirement, please exit the function.
3.The energy-saving e󰀨ect will be weakened when the outdoor
ambient temperature is too low or too high.
4.This function is only available for 1by1(mono) models and is
invalid for 1by2~1by5(multi) models.
5.The energy-saving rate is from laboratory comparison data
between normal running in high wind speed without the 3-Level-Eco
function selected and running with this function selected.

only applicable to mono models
