Haier AU122AEERA - AD122 ALERA Installation; Installation Space; Installation Steps

Electric wiring
21
Installation Procedure
(2) Wiring connection
For model AU122, make wiring to supply power to indoor unit, so that the power
for outdoor unit is supplied by terminals
For the others, make wiring to supply power to the outdoor unit, so that the power
for the indoor unit is supplied by terminals.
For the detailed wiring connection with the indoor units, see the corresponding indoor
operation and instruction manual.
For: AU122AEERA
FIG.2
POWER SUPPLY
380 400V, 3N~, 50Hz
N 1 2 3
Y/G
To Indoor Unit
R S T
FIG.2
For: AU36NAHERA, AU48NAIERA, AU60NAIERA
OUTDOOR UNIT
TERMINAL BLOCK
FIG.1
1 2 3
To Indoor Unit
Y/G
For: AU182AFERA
AU242AGERA AU282AHERA,
AU362AHERA AU362AIERA,
AU422AIERA AU522AIERA
L N
WARNING!
INTERCONNECTING WIRES MUST BE WIRED ACCORDING TO FIG.1,
FIG.2
,FIG.3 INCORRECT WIRING MAY CAUSE EQUIPMENT DAMAGE.
(3) Wiring procedure
1) Remove set screws on the side before taking off the front panel toward
the direction shown in figure.
2) Connect wires to the terminal block correctly and fix the wires with a
wire clamp equipped nearby the terminal block.
3) Route the wires in a proper way and penetrate the wires through the
opening for electric wiring on the side panel.
9. Test run
CAUTION!
THIS UNIT WILL BE STARTED INSTANTLY WITHOUT "ON" OPERATION
WHEN ELECTRIC POWER IS SUPPLIED.BE SURE TO EXECUTE "OFF"
OPERATION BEFORE ELECTRIC POWER IS DISCONNECTED FOR
SERVICING.
This unit has a function of automatic restart system after recovering power stoppage.
OUTDOOR UNIT
TERMINAL BLOCK
POWER SUPPLY
1PH, 220 230V~, 50Hz
1 2 3
Y/G
To indoor unit
OUTDOOR UNIT
TERMINAL BLOCK