3. The stability can be checked by alternately bum-
ping on the diagonals. The slightly swaying should
be the same in both directions. Otherwise the
frame can warp; possible leaking door seals are
the result. A low tendency to the rear facilitates
the closing of the door.frame can warp; possible
leaking door seals are the result. A low tendency to
the rear facilitates the closing of the door.
Notice
In the future use of refrigerator, doors uneven phenomenon may occur to the weight of
stored food. Then please adjust according to the above methods.
A
B) Using spacers
▶ Open the upper door and lift it.
▶ Carefully clip the spacer (enclosed in the accessory
bag) in the white plastic ring of the middle hinge
by hand or using tools like pliers. Do not scratch or
bruise the door.
Fine tuning of the doors
If the doors are not in one level, this mismatch can be
remedied by following:
A) Using adjustable foot
Rotate the adjustable foot according to the direction of
arrow to turn up or down the foot.
3.
B
36
EN
Installation
To Next Page
Loading...
Need help?
General
