Haier Cube 90 Series User Manual

26
EN
9. Installation
Aligning the appliance
The appliance should be placed on a
solid, flat surface.
1.
Tilt the appliance slightly backwards.
2.
Set the feet to the desired level.
Make sure the distance to the wall on the
hinge side is at least 100 mm to ensure that the door can open properly.
3.
Check stability by alternately bumping diagonally; the slight swaying should
be
the same in both directions. If this is not the case, the frame may be warped
;
leaking door seals may result. A slight slope
to the rear facilitates the closing
of the door.
Fine tuning of the doors
If the doors are not
on a
level, this mismatch can be remedied
as
follows:
A)
Using the adjustable foot
Rotate the adjustable foot
in the direction of the arrows
to
raise or lower
the foot.
B)
Using spacers
Ź
Open the upper door and lift it.
Ź
Carefully clip the spacer (enclosed in the
accessory bag) in
the white plastic ring of the middle hinge,
by hand or using
a tool such as pliers. Do not scratch or bruise the door.
Notice
During future use of refrigerator, the phenomenon of uneven doors may occur due to the weight
of the food stored; please adjust using the methods described above.

Haier Cube 90 Series Specifications

General

Brand	Haier
Model	Cube 90 Series
Category	Refrigerator
Language	English