40/88
【Setting of special functions】
1. Setting of password value
When the low temper ature refrigerator is firstly used, unlock password is 06. After
unlocking, press “Function Selection” and “Buzzer Cancel”for 5 seconds simultaneously,
06willbedisplayedonthedisplay,thenpress“▲”and“▼”toadjustthepasswordvalues.
Password value can be chosen among 05, 06, 07……29, 30. No operation will be done
within 5 seconds after the password value is set, then it will enter the lock status
automatically,indicatingthepasswordvaluesetisvalid.Whenunlockthepasswordvalue,
thedisplayfigurescanbedisplayedamong01,02,03……98,99.
2. Setting of start delay
Undertheunlockstatus,pressandholddown“FunctionSelection”and“▽”for5seconds
atthesametime.Startdelayofhightemperaturecompressoris01(1minute)whenthe
displayindicatesthattheequipmentisenergized,thenthestartdelaycanbesetas01,02,
03‐‐‐‐‐‐09, 10 (1 minute‐10 minutes) by pressing “ “△ or” ▽ “. The default delay is 1
minute.
3. Calibration function
Under the unlock status, press and hold down “Function Selection” for 5 seconds.
Temperature calibration value will be displayed on screen display area, at this time, the
difference between display temperature and that at the special point inside the
refrigeratorwillbecalibrated.Forexample,displaytemperatureis‐80℃and
temperature
ataspecialpointis‐75℃,then+5℃canbeinputtochangethedisplaytemperatureinto
‐75℃,therefore thecalibrationrangeis±5℃.
4. Control of condensate fan
When the compressor is turned on, the two fans also will be turned on; when the two
compressorsareturnedoff,thetwofanswilldependonthefollowingconditionsforonor
off:whenthe ambienttemperature is higherthan 20℃, the twofans will beturnedon;
whenitislowerthan20℃ (exceptfor20℃),onefanwillbeturnedoffandtheotherwill
beturnedoff;whenthe ambienttemperatureislowerthan 12℃ (exceptfor12℃),the
To Next Page
Loading...
Need help?
General
