Dishwasher does not work:
* Check if the circuit breaker needs to be resetor if the fuse needs to be replaced.
* Check if the unit is in "OFF" mode.
Check if the door is open. You may need to close the door properly.
Check that you have pressed "POWER" button after proper selection.
Dishware and glassware/flatware are cloudy
and not properly cleaned:
• Use of old or poor detergent.
You need to makesure that detergent is fresh.
. Thewater may be hard in your area.
Youmay needto installa water softener.
Spray arms may be blocked.
You may need to rearrange dishware and utensils.
• Water pressure may be low.
You may need to adjust the water pressure.
Make sure it is between 20 to 120 (PSI).
. Water temperature may be lower than what is recommended.
(120 Degree F / 49 Degree C) You may need to adjust the water temperature on
your water heater.
Overloading of dishware.
You may need to rearrange or remove some dishware from the load.
(May have selectedwrong cycle.) Inappropraite cycle selection.
You may need to select the proper cycle.
Dishes are not dry:
* Low water temperature.
You may need to regulate the water temperature to 120 Degree F / 49 Degree C
or select Sanitize Wash option.
Make sure the rinse agent dispenser is filled and the proper amount is used.
Avoid nesting and do not overload.
Load items in a tilted position if possible so the water will run off easily.
Dishware washed in higher temperatures will dry faster.
Some plastic materials may need to be towel dried.
26
To Next Page
Loading...
