Dishwasher will not fill:
* Check the water supply.
Make sure that the water supply is in "ON" position.
* Check water pressure.
Make sure the water pressure is at the proper level. (Be_een 20 - 120 PSI)
Water found under the filter:
* A smallamountof water found under thefilter area after completionof the cycle
is normal.
Detergent found in the compartment:
* Do not load itemstoo closeto thedetergentcompartment.Thismay block the
automaticreleaseof thedetergent.
* Do not useold or caked/dried detergentin thecompartmentbecauseit will not
dissolveproperly and will leavea sandyresidueon dishware.
Dishwasher is running for too long:
* Thetemperatureof incomingwater is below 120°E Raisingyour water heater
settingwill helpto shortenthe timeof operation.
* Call the Haler CustomerSatisfactionCenterif this doesnot resolvethe problem.
Beeping Sound and Flashing Light(s):
* Thedishwasherdoor is notclosedproperly.
After pressingthe "START/PAUSE"buttonto startthewash processand if the
door is notclosedproperly or thedoor is opened in the middleof the wash
process,you will noticethe following,
- The 1st light from the left of "Wash ProgramsIndicator Lights"will flash.
- Themachinewill continueto beepevery few seconds.
* Closethe door properly.Themachinewill stopbeeping.Theselectedwash
program lightwill flash and the wash processbegins automatically.
* If the dishwashermalfunctionsin the middle of thewash operation, the"Wash
ProgramsIndicatorLights"will flash and the machinewill beep.
29
To Next Page
Loading...
