Check List for Wash Process:
1) Make sure all itemsare loaded in the racks and silverware Basket properly.
(Rebr to page 15)
Note: Do not load tall dishware or cookware itemsnear the middle spray arm
Because it may Blockthe spray arm from rotating.
2) Pour the proper detergent into the detergent dispenser.
Note: If rinse aid compartment is empty, add "Rinse Aid" agent at this time.
3) Close the door and latch properly.
4) Turn on the power Button.
5) Select your desired wash program (Refer to page 1O/and option(s) (Refer to
page 11) based on the load and soil type.
6) Pressthe "START/PAUSE" button once to start the wash process. Pressthis button
once again if you want to "Pause" the activity during the wash process in order
to add or remove items.
Note: Selected wash program and option(s) blinking light(s) will indicate that the
wash process has begun and is running. When paused, the selected wash
program and option(s) light(s) will Be still. This indicates that wash
process is paused.
7) At the end of the wash program, the machine will beep a few times to indicate
that the wash process has finished. Simply shut off the unit by pressing the
"POWER" Button.
Note: DO NOT open the dishwasher door immediately Because the moist hot
air remaining inside the tub may cause harm.
Warning: Keep children away from the machine when the door is
Jeff to dry the dishware because the moist hot air is
exiting out of the door may cause harm.CartceJirtg or
Resetting Wash Cycle
7
To Next Page
Loading...
