GB
10- Installation
10.1 Unpacking
▶ Take the appliance out of the packaging.
▶ Remove all packaging materials.
10.2 Environmental conditions
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, refrigerators) without isolation.
10.3 Space requirement
Required space when door is opened (Fig. 10.3):
D1
D2
D3
D4
D5
W1
W2
10.3
WARNING!
▶ The appliance is heavy. Always handle with at least two persons.
▶ Keep all packaging materials out of children´s reach and dispose them in an environ-
mentally friendly manner.
10.4 Ventilaton cross-section
safety reasons, the information of the required venti-
lation cross sections must be observed (Fig. 10.4).
>10 cm
>10 cm
mc 01>
83 cm
mc2.591
10.4
10.5 Aligning the appliance
The appliance should be placed on a at and solid sur-
face.
1. Tilt the appliance slightly backwards (Fig. 10.5).
2. Set the feet to the desired level.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slightly swaying should
be the same in both directions. Otherwise the
frame can warp; possible leaking door seals are
the result. A low tendency to the rear facilitates
the closing of the door.
m
ax 45°
1.
2.
3.
10.5
31
Width
in mm
Depth
in mm
Distance to wall
in mm
W1 W2 D1 D2 D5
830 1424
600 885
50D3 D4
1034 1130
This refrigerating appliance is not intended to be used
as a built-in appliance.
To Next Page
Loading...
