Haier HM-07C03 - Page 16

Page 28 Page 27
INSTALLATION AND REPAZRING
NOTE:
In order to make the air conditioner to work effectively, first need to calculate the cooling capacity of the air
conditioner, according to the room size and surroundings. After selecting a proper one and putting it in a su-
itable work place, place, please confirm the place to install the air conditioner referring to the following ins-
truction:
1. Better install the outdoor unit in the outdoors to make
an easy heat exchange. The ideal place: out of window,
balcony, corridor and so on. To make the oudoor have an
easy heat exchange, please leave the distance between
the back of outdoor unit and the wall or other things no
less than 5CM. (Fig.1)
The specific installation process refers to installation.
The bracket to support the outdoor unit should be strong
and firm, and endure the pressure of the unit. Regularly
check the bracket about its firm condition and rusted
degree to avoid accidents.
Only using the connecting pipe to hang the outdoor unit
is definitely forbidden.
2. The left side of indoor unit should leave the objects
(such as curtain. wall, etc) no less than 20CM. To guarantee
smooth ventilation the alien things should not block outlet.
(Fig.2)
3. The connecting pipe can cross the chink of the window.
When the unit in operation, the window should be closed
as tight as possible to avoid the loss of energy. (Fig.3)
4. If you want to close the window tight, you can cut a
2
55 25mm hole in the window frame, the location of the
hole can be decided according to concrete condition. After
the connecting pipe crossing the window, sealing glue
should be used to avoid entering of water. (Fig.4)
Fig. 4
Fig. 3
Fig. 2
Fig. 1
20cm
20cm
PERFORMANCE CURVE
220V-- 50Hz-- 1PHASE
SUCTION GAS TEMP.-- 35 ( C)
UNDER COOL ---------- 8.3 ( K)
AMBIENT TEMP. ---- -- 35 ( C)
RUNNING CAPACITOR--25 MFD
45
50
55
60
80
70
60
50
40
30
1100
1000
900
800
700
5.0
4.5
4.0
3.5
3.0
3500
3250
3000
2750
2500
2250
2000
1750
CAPCITY (W) CURRENT (A) INPUT (W)
CONDENSING TEMP. ( C)
EVAPORATING TEMP.
FLOW RATE (kg/h)
45
50
55
60
-5 0 5 10 (C)
60
55
50
45
60
55
50
45