Why my Haier Air Conditioner does not run?
If the Haier Air Conditioner does not run, it could be due to a few reasons. First, the protector might be tripped, or a fuse might be blown. In this case, wait for 3 minutes and try starting it again, as the protector device may be preventing the unit from working. Also check if the plug is properly plugged. If the batteries in the remote controller are exhausted, replace them.
What to do if Haier HPN12XHM Air Conditioner runs but not cool?
If your Haier Air Conditioner runs but doesn't cool, several factors could be at play. Check if any doors or windows are open and close them. Ensure that the air filter is clean; if it's dirty, please clean it. Also, make sure that neither the air outlet nor the intake is blocked. Avoid using other heating appliances like heaters or lamps in the same room. Finally, verify that the set temperature isn't too high.
Why does my Haier Air Conditioner run a short while only?
If your Haier Air Conditioner runs for only a short while, it might be because the set temperature is too close to the room temperature; try lowering the set temperature. Another possibility is that the air outlet is blocked by an obstacle; remove the obstacle to allow proper airflow.
What to do if Haier Air Conditioner does not run and water full indicator lights?
If your Haier Air Conditioner does not run and the water full indicator light is on, drain the water into a prepared container using the drainage pipe on the rear panel of the unit. If the issue persists, consult a qualified technician.
Record model and serial numbers, and attach sales receipt for warranty.
Prepare the unit for operation, including placement and electrical connection.
Instructions for operating the air conditioner, including modes and water drainage.
Procedures for storing the unit after a long period of non-use.
How to turn the unit on and off using the control panel.
Selecting cooling, dehumidification, fan, or heat modes.
Adjusting the fan speed for different modes.
Setting the timer for automatic turn-off or turn-on.
Adjusting the desired temperature for cooling or heating.
Understanding the information shown on the LCD screen.
How to turn the unit on and off using the remote control.
Selecting cooling, dehumidification, fan, or heat modes via remote.
Adjusting fan speed using the remote control.
Setting the timer using the remote control.
Adjusting the desired temperature with the remote.
Information displayed on the remote's LCD screen.
Instructions for storing the air conditioner when not in use.
Common issues and solutions for the air conditioner.
Steps to follow to obtain warranty service or repairs.
General| Fan Speeds | 3 |
|---|---|
| Refrigerant | R410A |
| Cooling Capacity | 12000 BTU |
| Noise Level | 50 dB (Outdoor) |
| Features | Sleep Mode |
| Indoor Unit Noise Level | 24 dB |
| Outdoor Unit Noise Level | 50 dB |
| Indoor Unit Dimensions (WxHxD) | 790x270x190 mm |
| Outdoor Unit Dimensions (WxHxD) | 700x480x275 mm |
| Indoor Unit Weight | 9 kg |
| Outdoor Unit Weight | 32 kg |
To Next Page
