Power Control 
The power control turns the unit on and off.
Mode Control
 
The Mode Control has 4 settings:
 • Cool  • Dehumidify  • Fan  • Auto
The settings are adjusted by Mode Control button.
•  Cooling Mode
 
During the cooling mode the air is cooled and 
hot air is exhausted to the outside air through 
the air exhaust hose.  Adjust fan speed and  
temperature to suit your desired comfort level.   
Note: The air exchange hoses must vent  
outside the room when using Cool Mode.
•  Dehumidify Mode
 
Air is dehumidified as it passes through air 
conditioner, without being in full cooling mode.  
If room temperature is greater than 77˚F, fan 
speed can be adjusted; otherwise fan speed is 
fixed to “low.” 
Note: 
The warm air exchange hose must vent 
inside the room when using Dehumidify Mode, 
not outside as it does when cooling.  If the unit 
is vented outside when using Dehumify Mode  
some cooling will occur.
•  Fan Mode
 
Air is circulating throughout the room with no 
cooling. 
Note: Unit does not need to be vented in  
Fan Mode.
•  Auto Mode
 
Turn on the unit and choose “Auto” mode.   
The unit will switch its mode and fan speed 
automatically based on the environment  
temperature.
Fan Speed Control
 
The Fan Speed Control has 4 settings: Auto, 
High, Medium and Low.
Temp Set Controls
 
Press “Up” or “Down” to set temperature.  The 
setting range is from 64˚ to 89˚F.
Note: When using Auto, Dehumidify or Fan 
Mode, temperature setting button is invalid.
Fahrenheit / Celsius Selector 
 
Press the ˚C / ˚F switch button, to switch between 
˚F and ˚C. 
Note: Initial setting is ˚F.
Timer Setting Control
 
•  When you use the timer setting button while the 
unit is operating, you can preset a time for the 
unit to turn off.
•  When you use the timer setting button while the 
unit is on standby, you can present a time for 
the unit to turn on.
•  If you press the "ON/OFF" button, the preset 
timer function will be cancelled.
• Timer setting range is 1~24 hours. 
Timer Cancel Control
 
•  You can cancel the timer setting at any time by 
pressing the "Cancel" button.
8
Operation
Remote Control
English