Door removal
Removing the door
If your house door is too narrow, remove the refrigerator door and
carry the refrigerator in narrow side first.
Defrosting · Cleaning
Defrosting
The appliance defrosts automatically.
Cleaning
Clean the refrigerator regularly to prevent
odour build-up.
● For safety reasons, first unplug the power cord.
● Clean the appliance using a soft rag or sponge and
lukewarm water, to which you may add a little bit of
a neutral dishwashing liquid.
● Dry off surface water with a rag.
Water coupler
1) Unscrew the hinge covers. Disconnect all wires
except for the grounding wire.
2) Remove the screws from the upper hinge following the
direction as indicated by Arrow (1). Then remove the
upper hinge following the direction as indicated by
Arrow (2).
3) Lift the freezer compartment door to remove it. Next,
lift the door enough to be able fully pull out the water
line.
Remove the toe moulding, and
then release the water coupler.
Slide the toe moulding up to remove it, and then
release the water coupler while pressing on area (1) as
shown in the illustration.
Toe moulding
● Be sure to clean the door seal regularly.
Upper
Caution: Do not use pointed objects, metal brushes or the following chemical
solvents:
abrasive cleansers, varnish, amyl acetate, hot water, acid, alkaline cleaners, etc.
Remove the freezer compartment door.
Caution: Do not pour water onto the appliance.
Use a rag or sponge to clean and dry the controls and lights.
screw
Hinge cover
Grounding wire
Wires
Upper hinge
Lower
To Next Page
Loading...
