Setting up the Refrigerator/Freezer Combo 
Dispenser operation 
Dispenser operation 
Choose crushed ice, refrigerated water or ice cubes. Slightly push a glass against the ice/water 
lever as shown in the illustration. 
(1) Dispensing crushed ice 
●  Press the appropriate button so that the indicator 
for crushed ice lights up. 
●  Lightly press against the lever so that crushed ice 
is supplied. 
(2) Dispensing ice cubes 
●  Press the appropriate button so that the indicator 
for ice cubes lights up. 
●  Lightly press against the lever so that ice cubes are 
supplied. 
(3) Dispensing refrigerated water 
●  Press the appropriate button so that the indicator 
for refrigerated water lights up. 
●  Lightly press against the lever so that refrigerated 
water is supplied. 
 
 
 
Dispensing crushed ice 
●  Even with the ice cube option selected, some crushed ice may be supplied simultaneously. It is 
also possible that the crushed ice supply is mingled with a few ice cubes. 
●  When crushed ice is frequently called for, it is normal for frost to build up around the outlet, but 
it will eventually evaporate. 
●  Keep the glass close to the dispenser to prevent ice from spilling. 
Dispensing refrigerated water 
●  Due to air in the water supply line, refrigerated water may not be available immediately after 
installation. In this case, hold the dispenser lever pressed in for as long as two minutes to 
evacuate any remaining air.  
●  After that, the supplied water will become increasingly cooler. 
●  Refrigerated water does not contain any ice cubes. To lower the temperature of the refrigerated 
water, add crushed ice or ice cubes to it. 
 
 
 
 
Caution: Keep fingers and objects away from the dispenser.
Be sure to choose a flat and level setup location. Use 
sturdy and fireproof supports to correct an 
unevenness in the floor. Turning an appliance foot 
clockwise raises the appliance, turning it 
anticlockwise lowers the appliance.
 
Height difference
Height difference
Left screw
Protect the setup location against direct sunlight or 
heat sources.
 
Height difference
Wrench
Height difference
Right bolt
Avoid a damp setup location. Remove water and 
dirt with a soft rag.
 
Be sure to leave at least 10 cm of space around the 
appliance. When installing the appliance in an 
enclosed area, leave at least 25 cm of space on the 
sides and 5 cm on the top and back.
 
Door adjustment
If the freezer compartment door is lower than that of the 
refrigerator compartment, insert the wrench in the groove 
of the left screw and turn it in the direction of the arrow 
until both doors are the same height.
 
If the freezer compartment door is lower than that of the 
refrigerator compartment, insert the wrench in the groove 
of the left screw and turn it in the direction of the arrow 
until both doors are the same height.
 
Wrench 
Caution: Keep fingers and objects away from the dispenser. 
Spacing