3-1-6
Disassembly of the ice maker
①Take out ice storage box and shelf;
②Remove the 2 screws at the top of the
●
front, pull slightly, after the ice maker
assembly separate with the top of
refrigerator, the connector terminal
●
appears at the left side of the back,
●
separate the connector terminal then
take out the ice maker assembly.
●
Note: the movement range can not be
too large, in case damage the cable
jumper.
3-1-7
Disassembly of water tank cover and water tank
① Put your fingers into the
disassembly mouth of the water
tank cover as shown in the
●
picture, pulling slightly ramp
above is able to loosen the snap
joint of the water tank cover.
②Grasp the loosened water tank
cover, pulling slightly towards the
left as shown in the picture is
able to take down the water tank
cover from the door.
To Next Page
Loading...
