③Hold down the fixed card towards
the water tank, pull out the two
pipes.
Note: before pulling out the pipes,
please empty water in all pipes of
the refrigerator, in case the water
●
saptters.
●
④Remove two fixed screws under
the water tank, pull towards the
right is able to take down the water
tank from the door.
3-1-9 Assembly of water tank and water tank cover
1.Install the water tank on the door, fix the water tank with two screws 0060600097 at the bottom, do not pin the
two pipes.
2.Connect the white pipe to the left faucet of the water tank, and connect the blue pipe to the right faucet of the
water tank, please make the color code cling the fixed card, make it water-tight.
3.Fix the water tank cover: ①Incline the water tank cover towards the operator, firstly install the right to the boss
on the door; ②Push the left side of the water tank cover towards the door to make the jack catch get stuck in
the columnar side of the water tank; ③Pat upside of the water tank cover until the jack catch get stuck in the
upper snap joint, mean that the upside of the water tank cover is not loose; ④Pat downside of the water tank
cover until the jack catch get stuck in the lower snap joint, mean that the downside of the water tank cover is not
loose, there is no gap between the door and water tank cover.
To Next Page
Loading...
