Parts and Functions
When the remote controller appears abnormal,
use a sharp pointed article to press this button
to reset the remote controller normal.
1.RESET
Used to select TIMER ON, TIMER OFF,
TIMER ON-OFF.
3. TIMER button
Used to set correct time.
4. CLOCK button
Used to select sleep mode.
5. SLEEP button
6. MODE button
AUTO COOL DRY FAN HEAT
Used to set clock and timer setting.
7. HOUR button
Used to set healthy operation.
8. HEALTH button
Used for unit start and stop.
9. ON/OFF button
10. TIMER ON display
11. FAN SPEED display
LOW HI
MED AUTO
12. LOCK display
13. SWING UP/DOWN display
14. SLEEP display
15. HEALTH display
Used to select your desired temperature.
Operation mode
AUTO HEAT FANCOOL DRY
Remote controller
16. Operation mode display
Display board
18. Left/right air flow display
Remote controller: to display the TEMP. setting.
19. TEMP display
20. TIMER OFF display
21. TIMER display
22. TEMP button
Used to select fan speed: LOW,MED, HI, AUTO.
23. FAN button
Used to set the health airflow mode.
24. HEALTH AIRFLOW button
25. SWING UP/DOWN button
Used to select up or down air sending direction.
26. SWING LEFT/RIGHT button
Used to select left/right air flow.
Used to confirm timer and clock settings.
27. SET button
Used to lock buttons and LCD display. If pressed, the
other buttons will be disabled and the lock condition
display appears. Press it once again, lock will be
canceled and lock condition display disappears.
28. LOCK
13
29. Ambient temp.display
19
28
16 1429 1510 20
17.Singal sending display
2.LIGHT button
Control the lightening and extinguishing of
the indoor LCD display board.
NOTE:
Cooling only unit do not have functions and displays related with heating.
When receiving the remote control signal, display the set
temperature and in the rest time the room temperature is
displayed and this room temperature is only for reference.
Air Conditioner
To Next Page
Loading...