Installation
Connecting water to the appliance
37
1. Remove the rubber plug (1) from the water
inlet valve.
2. Firmly push the water tube onto the water
inlet valve and tighten up the collar nut.
This water pipe needs to be cut from the
middle and used, and the other section is
used as a spare part.
①
Connecting to the water tap
This feature is only available on some models.
1. Push the water tube into the hole of the tap con-
nector supplied in the accessories. The pipe should
be held rmly whilst the connector is pushed onto
the pipe.
2. Ensure that the rubber washer is tted to the
inside of the tap connector before screwing it onto
the tap.
▶ A separate connector or adaptor may need to be
purchased if your tap tting does not match the
thread size of the connector provided.
Checking the Water Connection
This feature is only available on some models.
▶ Turn on the water supply and switch on the appliance. Carefully check all ttings
for possible leaks due to poorly tted hoses.
▶ Press and hold the 3Sec.Filter Reset button for three seconds. The new water
lter has been activated.
▶ Place a cup under the water dispenser to verify that water is owing through the
appliance.
▶ Check the connecting tube and joints for leaks once again.
To Next Page
Loading...
