Safety information
Before switching on the appliance for the rst time read the
following safety hints!:
WARNING!
Before rst use
▶ Make sure there is no transport damage.
▶ Remove all packaging and keep out of children´s reach.
▶ Wait at least two hours before installing the appliance in order to ensure the re-
frigerant circuit is fully ecient.
▶ Handle the appliance always with at least two persons because it is heavy.
Installation
▶ The appliance should be placed in a well-ventilated place. Ensure a space of at
least 10 cm above and around the appliance.
▶ Never place the appliance in a damp area or location where it might be splashed
with water. Clean and dry water splashes and stains with a soft clean cloth.
▶ Do not install the appliance in direct sunlight or in the near of heat sources(e.g.
stoves, heaters).
▶ Install and level the appliance in an area suitable for its size and use.
▶ Keep ventilation openings in the appliance or in the in-built structure clear of
obstruction.
▶ Make sure that the electrical information on the rating plate agrees with the
power supply. If it does not, contact an electrician.
▶ The appliance is operated by a 220-240 VAC/50 Hz power supply. Abnormal
voltage uctuation may cause the appliance to fail to start, or damage to the
temperature control or compressor, or there may be an abnormal noise when
operating. In such case, an automatic regulator shall be mounted.
▶ Do not use multi-plug adapters and extension cables.
▶ Do not locate multiple portable socket-outlets or portable power supplies at the
rear of the appliance.
▶ Ensure that the power cable is not trapped by the refrigerator. Do not step on
the power cable.
5
To Next Page
Loading...
