Haier HSW59F18EIMM - Page 38

EN
Installation
Fine tuning of the doors
If the doors are still not in one level after level-
ling the doors by the feet , this mismatch can
be remedied by turning the hinge lifting shaft
at the right bottom corner of refrigerating door
with a spanner( Fig .8)
Clockwise turn lifting shaft with spanner to
lower door height ( Fig .9).
Antic lock wise turn lifting shaft with spanner to
llft door height ( Fig .10).
Waiting time
To the maintenance-free lubrication oil is
located in the capsule of the compressor.
This oil can get through the closed pipe
system during slanting transport. Before
connecting the appliance to the power
supply you have to wait at least 2 hours so
that the oil runs back into the capsule.
2 h
WARNING!
Do not adjust the hinge lifting shaft excessively to a height which might cause the
shaft to leave its original locked position .( Adjustable height range :3 mm )
Electrical connection
Before each connection check if:
▶ power supply, socket and fusing are appropriate to the rating plate.
▶ the power socket is earthed and no multi-plug or extension.
▶ the power plug and socket are strictly according.
Connect the plug to a properly installed household socket.
38
Fig.8
Fig.9
Fig.10