EN
Installation
WARNING!
To avoid risks a damaged power cord must be replaced by the customer service
(see warranty card).
Removing and installing the doors
In the event that you need to remove the appliance doors , please follow the door
removal and installation instructions below .
WARNING!
▶ Before any operation , deactivate the appliance and disconnect the mains plug
from the mains socket .
▶ Block the water supply .
▶ The applance is heavy . Always handle with at least two persons .
▶ Do not tilt the appliance more than 45 or place it horizontally on the ground .
▶ The door may fall over and hurt people , or get damaged during these steps ,
please pay more attention when rermoving and instaling doors .
1.Release the left side of two water
couplers on the front left corner at the
bottom of appliance : press and hold
in the collar as shown and remove the
water pipe .( Fig .11).
2.Undo the hinge cover screw and
remove the cover ( Fig .12). When re-
moving the freezer door , disconnect all
wires except for the grounding wire .
39
To Next Page
Loading...
