Installation
Connecting water to the appliance
39
1. Remove the rubber plug (1) from the water
inlet valve.
2. Firmly push the water tube onto the water
inlet valve and tighten up the collar nut.
This water pipe needs to be cut from the
middle and used, and the other section is
used as a spare part.
①
Connecting to the water tap
This feature is only available on some models.
1. Push the water tube into the hole of the tap con-
nector supplied in the accessories. The pipe should
the pipe.
2.
inside of the tap connector before screwing it onto
the tap.
A separate connector or adaptor may need to be
thread size of the connector provided.
Checking the Water Connection
This feature is only available on some models.
Press and hold the 3Sec.Filter Reset button for three seconds. The new water
appliance.
Check the connecting tube and joints for leaks once again.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
