Haier HSW79F18CIMM - Appliance and Door Adjustment; Appliance Alignment and Stability; Door Alignment Adjustment

Installation
Fine tuning of the doors
If the doors are still not in one level after level-
ling the doors by the feet , this mismatch can
be remedied by turning the hinge lifting shaft
at the right bottom corner of refrigerating door
with a spanner( Fig .8)
Clockwise turn lifting shaft with spanner to
lower door height ( Fig .9).
Antic lock wise turn lifting shaft with spanner to
llft door height ( Fig .10).
WARNING!
▶ Ensure that the connections are always rm , dry and leak free .
▶ Make sure the hose is never crushed , kinked , or twisted .
Aligning the appliance
The appliance should be placed on a at and
solid surface .
1. Tit the appliance slightly backwards ( Fig .7) .
2. Set the feet to the desired level . Make sure
the distance to the wall on the hinge sides is at
least 10 cm .
3. The stability can be checked by alternately
bumping on the diagonals . The slightly swaying
should be the same in both directions . Other-
wise the frame can warp ;possible leaking door
seals are the result . A low tendency to the rear
facilitates the closing of the doors .
40
Fig.8
Fig.9
Fig.10
Fig.7