Haier HTF-452WM7 - Ice Cube Maker Usage; Energy Saving Tips

GB
Equipment
Notice:
Do not bring water between the 2 buttons, otherwi-
se the buttons maybe frozen and the ice cubes can-
not drop into the storage box.
21
Ice cube maker
1. Pour fresh drinking water into each ice-making box
as per the scale mark inside the measuring cup, do
not exceed the scale mark
1.
The Light
The LED interior light comes on when the door is opened. The performance of the lights
is not aected by any of the appliances other settings.
Energy saving tips
▶ Make sure the appliance is properly ventilated (see INSTALLATION).
▶ Do not install the appliance in direct sunlight or in the near of heat sources(e.g. sto-
ves, heaters).
▶ Avoid unnecessarily low temperature in the appliance. The energy consumption in-
creases the lower the temperature in the appliance is set.
▶ Functions like POWER- FREEZE consume more energy.
▶ Allow warm food to cool down before placing it in the appliance.
▶ Open the appliance door as little and as briey as possible.
▶ Do not overll the appliance to avoid obstructing the air ow.
▶ Avoid air within the food packaging.
▶ Keep door seals clean so that the door always closes correctly.
▶ Defreeze frozen food in the fridge storage compartment.
2. Put the box into the freezing compartment.
3. After water becomes ice, take o the ice maker
out of the appliance and rotate the button by hand.
Then, ice blocks will fall into the ice box automati-
cally. Remove the cover and fetch the ice cubs.
3.