Before switching on the appliance for the rst time read the fol-
lowing safety hints!:
WARNING!
Before rst use
▶ Make sure there is no transport damage.
▶ Remove all packaging and keep out of children´s reach.
▶ Wait at least two hours before installing the appliance in order to
ensure the refrigerant circuit is fully ecient.
▶ Handle the appliance always with at least two persons because
it is heavy.
Installation
▶ The appliance should be placed in a well-ventilated place. Ensure
a space of at least 10 cm above and around the appliance.
▶ Never place the appliance in a damp area or location where it
might be splashed with water. Clean and dry water splashes and
stains with a soft clean cloth.
▶ Do not install the appliance in direct sunlight or in the near of
heat sources(e.g. stoves, heaters).
▶ Install and level the appliance in an area suitable for its size and
use.
▶ Keep ventilation openings in the appliance or in the in-built
structure clear of obstruction.
▶ Make sure that the electrical information on the rating plate
agrees with the power supply. If it does not, contact an electri-
cian.
▶ The appliance is operated by a 220-240 VAC/50 Hz power sup-
ply. Abnormal voltage uctuation may cause the appliance to
fail to start, or damage to the temperature control or compres-
sor, or there may be an abnormal noise when operating. In such
case, an automatic regulator shall be mounted.
▶ Do not use multi-plug adapters and extension cables.
▶ Ensure that the power cable is not trapped by the refrigerator.
Do not step on the power cable.
4
To Next Page
Loading...
