InstallingYourWineCooler
Unpacking Your Wine Cooler
1. Remove all packaging material. This includesthe foam base and all
adhesive tape holding the wine cooler accessoriesinside and outside.
Slide out and remove plastic or foam guard used to secure the
compressor from shipping damage due ta vibration and shack.
2. Inspectand remove any remains of packing, tape or printed
materials before powering on the wine cooler.
Leveling Your Wine Cooler
Yourwine cooler has four levelinglegs which are located in the
front and rear comers of your wine coder. After properly placing your
wine cooler in itsfinal position,you can level your wine cooler.
Levelinglegs can be adjusted by turning them clockwise to raise your
wine cooler or by turning them counterclockwise to lower
your wine cooler. The wine cooler door will close easier when the
leveling legs are extended.
Proper Air Circulation
• Toassureyour winecoolerworksat themaximumefficiencyit
wasdesignedfor, you shouldinstallit ina locationwhere there
isproperair circulation, plumbingand electricalconnections.
• Thefollowing are recommended clearances around the winecooler:
Sides............... 2 "(50ram)
Top.................... 2" (50mm)
Back.................. 2" (50mm)
• Do not over fill your wine cooler for proper internal air circulation.
To Next Page
Loading...
