ASSEMBLE
LEFTF_ME / RIGHT Fi_ME
Slide the left frame onto the air
conditioner cabinet using the tracks on
the fop and boflom of the unit. Slide the
frame as close to the air conditioner as
possible so that the cudain locks into
place. Gently pull the frame out until it
is the correct length for your application.
Install the left curtains and frames
in the same way,
J' 4
F
PREPARE
3 WINDOW FOR
INSTALLATION
1. This unit is designed for installation in standard double hung windows
with actual opening widths of 23,25" to 36". The upper and lower sash
must open sufficiently to allow a clear vertical opening of 12" from the
bottom of the sash to the window stool.
2. If slorm window presents inlerFerence, faslen a 2_ wide wood slrip (hal
included) (OUTER SILL) to the inner window sill across the full width of
the sill. The wood strip should be thick enough to raise the height of
the window sill so that the unit can be installed without interference by
the storm window frame (STORM WINDOW FRAME) or wood strip
(OUTDOORS) to help condensation to drain properly to the outside.
3. Install a second wood strip (approximately 6" long by 3/2" wide and
same thickness as firsl slrip) in the center of Ihe ouler sill flush against
the back off the inner sill. This will raise basepan angle.
4. If the distance belween STORM WINDOW FRAME and WOOD STRIP
MOUNTED ON TOP OF INNER SILL is more than 1", two wood
strips are not necessary.
INNER
SILL
uo
R
s I 1t4TERO
1"MAX
WOOD STRIP
MOUNTED ON _'1 I'_t-
TOP OF INNERSILL / 3/4" CLEARANCE
" M
I,,_R IWOOO_TRP__ O
IFOR BASEPAN iT----z-I U
NIANOLE I/ _ T
l) I I/OUTER D
ktSLLO
R I Iu R
S S
12
To Next Page
Loading...
