Why my Haier HWF10AN1 Washer fails to operate?
If your Haier Washer fails to operate, several factors could be at play. First, ensure the program has been started. Next, check that the door is properly closed. Verify that the machine is switched on and that there is no power failure. Lastly, check if the child lock is activated and deactivate it if necessary.
Why is my Haier Washer vibrating so much while spinning?
If your Haier Washer is vibrating strongly during spinning, first, make sure that all transportation bolts have been removed from the appliance. Then, ensure the appliance is on solid, level ground. Finally, check that the machine load is correctly balanced and within the specified weight limit.
Why there is no water in my Haier HWF10AN1?
If the Haier Washer is not filling with water, check the water tap to ensure it's open. Inspect the inlet hose for any kinks that might be blocking the water flow. Also, verify that the water pressure is at least 0.03 MPa. Ensure the door is properly closed and that there are no issues with the water supply.
What to do if my Haier Washer displays CLr FLtr?
If the Haier Washer is showing the error code 'CLr FLtr', it indicates a drainage error where water is not fully drained within 6 minutes. Check the drain hose installation.
What to do if my Haier HWF10AN1 has a drainage failure?
If the Haier Washer is not draining properly, unblock the drain hose. Also, ensure that the drain hose end is not higher than 100 cm above floor level by checking its installation.
To Next Page
General
