What to do if my Haier Washer stops running in midway?
If your Haier Washer stops mid-cycle, the most likely cause is that the top lid isn't fully closed. Make sure to close the top lid securely to resume the washing cycle.
What to do if my Haier HWM70-918NZP is not draining or drains too slowly and shows E1?
If your Haier Washer isn't draining properly and the display shows 'E1', it could be due to a few reasons. First, ensure the drain hose is placed down correctly and is not blocked. If it is blocked, clean out any obstructions. You can also try opening and closing the top lid once after adjusting the hose or cleaning any blockages.
What to do if my Haier HWM70-918NZP won't start?
If your Haier Washer isn't starting, there could be a few reasons: * Check if there is a power failure and ensure the power plug is tightly inserted. * Make sure the water level has reached the preset position. Alternatively, also ensure the top lid is closed properly and the laundries are set flat inside the machine. Make sure the power plug is tightly inserted.
Why is my Haier Washer not filling with water or filling slowly and shows E4?
If your Haier Washer is not filling with water or is filling slowly and shows 'E4', check the following: * Ensure the water tap is fully opened and that there isn't a water supply failure. * Check if the water inlet valve is blocked; if so, clean it. * Also, ensure that the water pressure is normal. Opening and closing the top lid once after performing these checks might help.
Why does my Haier HWM70-918NZP Washer make abnormal sounds?
If your Haier Washer is making unusual noises, inspect these potential issues: Ensure the machine is standing evenly. If not, adjust it. Also, check if the laundries are placed unevenly inside, especially during spinning; rearrange them if necessary and close the top lid. Finally, check for any foreign objects inside the machine and remove them.
What to do if my Haier HWM70-918NZP displays E3 and the spinning doesn't work?
If your Haier Washer displays 'E3' and the spinning function isn't working, it's likely due to the safety switch being activated. This can happen if the laundries are placed unevenly inside the machine or if the machine itself is not level. Try reordering the laundries evenly and close the top lid. Also, ensure the machine is placed horizontally, then open and close the top lid once.
Why is the water tap leaking on my Haier HWM70-918NZP Washer?
If the water tap is leaking on your Haier Washer, the screw of the jointer of the water inlet hose may be loose or awry. Try to fasten the screw of the jointer properly.
What to do if my Haier HWM70-918NZP Washer displays E0?
If your Haier Washer displays 'E0', it means the top lid was open during the reserve procedure. Make sure to close the top lid.
What does it mean if my Haier HWM70-918NZP Washer displays E6?
If your Haier Washer displays 'E6', it indicates that the water level sensor is bad. Please contact the after-sales service department.
Explains warning and forbidden signs used in the manual to ensure user safety.
Instructions for installing the bottom plate of the washing machine.
Guidance on leveling and positioning the washing machine correctly.
Checks required for the water faucet before connecting the inlet hose.
Detailed steps for connecting the water inlet hose to the faucet.
Procedure for connecting the water inlet hose to the washing machine.
Steps to connect the water inlet hose jointer to the hose.
Ensuring secure connections between the hose, jointer, and faucet.
Instructions on how to detach the water inlet hose.
Guide on how to reposition or change the direction of the drain hose.
Proper usage guidelines for the drain hose to ensure effective drainage.
Key checks and preparations for laundries before starting a wash cycle.
Instructions for adding and dissolving washing powder.
Guidance on using fabric softener correctly.
Instructions for adding and using laundry whitener.
Overview of washing programs and their suitable laundry types.
Steps for removing and cleaning the detergent dispenser.
General| Loading Type | Top Load |
|---|---|
| Capacity | 7 kg |
| Spin Speed | 700 RPM |
| Color | White |
| Water Level Selection | 5 Levels |
| Control Type | Mechanical |
| Display | LED |
| Child Lock | Yes |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Type | Washing Machine |
To Next Page
