１０
degrees, 5 times equals 5 degrees, and so on. Once you have selected the
temperature you desire, push the “Light/Set” button. Now the wine cooler is
INSTALLATION AND ACCESSORY PARTS
programmed and the LED readout will return to current internal temperature
reading.
z There will be a 3 degree variance +/- between the temperature you select and
the temperature indicated on the LED readout. This occurs because the wine
cooler activates and deactivates trying to maintain your desired temperature.
There is often a 10℃ variance between the top and bottom shelves of the
wine cooler. Therefore, if you have set the wine cooler for 10℃ and have a
mix of red and white wines, you may want to put the white wine on the bottom
shelf where the temperature will be 7℃ ,and place the red wine on the top shelf
where the temperature will be 13℃.
Mechanical Control Unit: See fig.#2
z Your wine cooler has a temperature control knob on the back of the
unit ,There are 6 settings:1 being the warmest and 6 being the coolest, You
can set the temperature of your wine cooler any setting you desire.
z Fig. #2
W
h
i
t
e
OFF
R
e
d
Mid Range
Coldest
To Next Page
Loading...
