Introduction
4. Remote Control Installing Batteries
1. Open the battery compartment cover on the back of the remote control.
2. Insert two 1.5V AAA size batteries observing the polarity markings inside the battery
compartment. Don’t mix di
Step 1 Step 2 Step 3
fferent types or used batteries with new ones.
3. Close the cover.
- The remote control should be operated within 30 feet (7m) and 30
0
to the left and right of the
IR receiver at the front of the TV.
- Used batteries should be disposed of properly.
HTR-D06A
Battery
Compartment
Cover
HTR-D06A
2 x AAA Battery
HTR-D06A
9
Base Stand Assembly Instructions Note: the pictures below are only for reference
The parts needed for installing the stand (supplied: Part1, Part2, Part3, Part4, Part5, Part6, Part7)
Setps:
2
3
4
6
7
1. Put the part2 to the part1, and
fix them with the screws
supplied as the picture showns.
2. Put the part3 and part4 to the
part 2.
3. Put the part6 an part7 to the
part5.
4. Put the part5 (including part6
and part7) to the part2
(including part3 and part4).
5. Fixing the part2, part 3, part 4
part5, part6, part7 with the
screws supplied as the picture
showns.
Screws:
4xB4x16
3
4
5
6
7
Screws:
6xB4x12
Step 1
Step 2
Step 3
Step 4
Step 5
1
Batteries shall not be exposed to excessive heat such as direct sunlight or fire.
To Next Page
Loading...
Need help?
General
