English
Selecting Wash/Rinse Temperature:
When you turn the power "ON", the initial temperature is
set at "Cold/Cold" position.
Press the "Temp Select Button" to select the proper temperature
option. For your convenience, there are three temperature
options: Cold/Cold, Warm/Cold and Hot/Cold.
Always refer to the label on the garment for proper
temperature that is recommended by garment manufacturers. See the reference
chart below to select proper temperature for the fabrics.
WASH/RINSE TYPES OF FABRICS
Cold/Cold Non-colors Fabrics, lingerie
with light or normal soil
clothes & special care fabrics
Warm/Cold Delicate & colors Fabrics
Hot/Cold Sturdy whites & colors
Fabrics such as work & play
clothes, soiled fabrics
Note: When selecting hot water option for your load,
• Incoming hot water must not exceed over 140 Degree F/60 Degree C.
• If the incoming hot water temperature exceeds over level shown above,
the display will show “E5” error code and it will beep.
• You must let the hot water cool down below the temperature level shown
above. Once the hot water has cooled down, you must press
“Start/Pause” button to resume the cycle again.
Start/Pause Button:
After selecting your options and closing the washer door properly, you need to
press the "Start/Pause" button to start the washer.
If you want to pause during the cycle operation, simply press "Start/Pause" button.
This will stop the activity during the cycle operation until you press this button again
to resume the cycle.
WARM/COLD
COLD/COLD
HOT/COLD
14
XQB60-91BF MANUAL 10/22/01 11:42 AM Page 15
To Next Page
Loading...
