12
Operation
(1) Press MENU key, you will enter function circulation, use
or
key to switch between dierent functions. Switch to the
Up/Down swing or Left/Right swing, then press MENU key
again to enter the setting of swing angle (only valid for part
of models). At this time you can use
or key to adjust the
swing angle. After adjustment, press MENU key to exit the
setting.
(2) After adjustment, if there is no operation within 10 seconds
or press MODE / FAN key, it will quit swing setting interface
and previous changes are valid.
Note:
When the communication protocol which the wired controller
adopts is the second version, the up/down swing and left/right
swing, or only the up/down swing is alternative by dip switch
SW7. (When the communication protocol is the third or rst
version, SW7 is invalid.)
Swing
To Next Page
Loading...
